AEG electronic instantaneous water heater, DDLE BASIS

Hot water: Instant & unlimited hot water for the bathroom, kitchen & more. Temperature: Constant temperature thanks to stepless adjustment. Easy to assemble: Flexible above or below table assembly possible. Economical: No line losses, low energy consumption. AEG DDLE Basis - Your comfort for warm water With the AEG DDLE Basis electronic instantaneous water heater you can bring high temperature comfort directly into your home. Whether you want to supply hot water to your bathroom, kitchen or both, this instantaneous water heater provides instant and unlimited hot water. Imagine always having the perfect temperature, without having to wait long. High temperature comfort for you: This instantaneous water heater supplies your entire house or apartment with hot water in an energy-saving manner and with little effort. You can easily power your washbasin, your shower, your kitchen sink and your bathtub (from an output of 21 kW) at the same time. Easy installation: The slim water heater is easy to install and is suitable for both over-table and under-table installation. It is ideal if you want to supply one or more nearby water sources. This is an easy way to save money: the short cable routes mean that there are no unnecessary cable losses. Technology at its best: The temperature can be adjusted continuously using application symbols. Thanks to the fast control electronics, you benefit from high temperature stability. The bare wire heating system is insensitive to calcification and ensures a long service life. Technical details at a glance: The instantaneous water heater is electronically controlled and offers you stepless power control. Operation is manual. It is jet-proof (IP 25) and can therefore also be installed directly in the shower and bathtub area. Note: A 400 V power connection (three-phase alternating connection) is required to install this device. The assembly (water and electrical installation) as well as the initial commissioning and maintenance of this device may only be carried out by a qualified electrician in accordance with the applicable regulations and in accordance with these instructions. A three-phase AC connection (high power connection) is required to operate this device. For devices with a nominal output of more than 12kW, the consent of the respective network operator must be available or obtained before initial installation. The device may only be installed with the consent of the network operator by the network operator itself or by an installation company that is registered in the installer directory of a network operator.